Page Comparison

Interpreting LPR flags

Here we have a typical LPR display. Notice the last read plate came from the right side Camera (indicated by the orange arrow beside the plate image)Image Removed

Image Added

Running Scan Total

The running total of how many reads you have done in a session is located on the right, just above the read list. 

In this case we have 30 reads total.Image Removed

Image Added

Visual Indicators During Scanning

Plates in Violation

Reads that are in violation are indicated by a red flag.

Image Removed

Image Added

Plates that are Valid

Reads that are valid are flagged as green.

Valid reads will list on the handheld unit but will not be chalked or passed into the system as part of the LPR events report.

Image Removed

Image Added

Plates Chalked

Reads that are still in the grace period configured in your system will be indicated by an orange flag.

Image Removed

Image Added

Toggle PL8-RDR Scanning

When editing a plate read the system will go into offline mode.  This is indicated by the green button shown below changing to red.

To continue scanning plates be sure to engage the ON button, make sure it's green before continuing.

Image Added

Scan for Plates-of-Interest Only

Alert-only scanning can be done by selecting the toggle at the top of the PL8RDR LPR Scanning panel.

Once selected:

• no permit validation will be performed
• vehicles will continue to be chalked
• alert notifications will be presented if a vehicle of interest is "seen"

Image Added

Related Pages