Note: this is assuming you have a pl8rdr PL8RDR computer already set up. See the PL8RDR information section for more details.
Powering the Camera
Your Survision camera should come with a cable. This is only used for providing power to the camera; the camera connects to the pl8rdr computer PL8RDR wirelessly. Power on both the pl8rdr computer PL8RDR and the Survision camera.
Connecting to a Handheld Device
In order to scan plates, the PL8RDR computer will need to be connected to a handheld device running the OPS-COM enforcement app. The PL8RDR will broadcast a Wi-Fi network, pl8rdr.opscom. Connect to this network on your device (the network password is T0maha3k).
You'll also need to enter the IP address of the camera into the OPS-COM app settings. The camera's IP address will be provided by your contact at OPS-COM. Enter it under System Settings → PikoPak Camera IPs.
Positioning the Camera
Choose a plate on a vehicle to be your reference. Park your enforcement vehicle behind it and to the side, as if you were driving past a street-parked car. The camera on your vehicle should be 5 meters away from the reference plate, and angled less than 30 degrees off the front of the plate.
(This diagram shows a vertical angle, but the same applies horizontally.)
The pl8rdr will broadcast a WiFi network: Connect to the pl8rdr.opscom (your contact at OPS-COM will provide you with a password if needed). Connect to this Wi-Fi network on a device of your choice. The screenshots in this demonstration are from a phone, but any laptop or mobile device should will work.
In your On your tablet (or other connected device) open a web browser, go to enter the IP address of the camera; your contact at OPS-COM will have provided you with the address.
Click on "Configuration assistant".
Proceed through the first 3 screens by clicking "Next" each time. These settings will have already been configured for you.
On the 4th screen, you will be prompted to set the camera angle. Adjust the camera on your vehicle until the plate you have chosen as your reference point is centered in the green box. The lines of text above the camera feed should all turn green when it is set correctly. When you are done, click "Next".
On the 5th screen, leave all the fields blank and click "Finish". The next screen may display an error message saying no address is configured. You can safely ignore this; the address is configured on the pl8rdr.
Your camera should now be set up at the correct angle. You can go through this quick setup process every time you need to reposition the camera on your vehicle.