Page Comparison

First Time Connection

Power up the camera and give it a few minutes to fully boot up.

At that point you will see the camera in your network connections list.
Note the network name reflects the seriel serial number of the camera In this case ANPR-2010011339
Click connect to establish a connection between your computer and the camera's hotspot.

The standard IP address for the camera coming from the factory is set at 192.168.150.1
You will also have to put the port number in your URL when trying to connect through your browser.

Open a browser and enter the camera IP and port into the address bar. In this case it will be 192.168.150.1:1080 (Where 192.168.150.1 is the camera IP and 1080 is the port number)

You will be prompted to enter a user name and password. 
Username superuser
Password superuser

You will then be directed to the Plate Reader Tab of the camera configuration.

There are Specific areas that you will need to configure.

On the Plate Reader tab you will edit:

General Settings
Event Actions Also known as TCP Events
JPEG Image Header Configuration
Plate Reader Settings

On the System tab you will edit:

Network Settings 
It is very important to edit the network settings properly and in a proper sequence. If for example you configure thecamera to connect to the PL8RDR but forget to set it to assign an IP (DHCP) and save the changes. You will not be able to log into the camera wirelessly.

Related Video

This video shows the process described above as to how to log into the camera for the first time.

Related Pages